Expert Commercial Roofers | Missoula, MT | Summit Roofing

Home
Commercial Roofing
- Versico Roofing Systems
- GAF Roofing Systems
Metal Roofs
Green Roofs
Gallery
About Us
Apply Here with BambooHR!
Contact
Employees
- Training Resources

Missoula

9550 Derby Drive, Missoula, MT 59808

Helena

1401 N Oakes St., Helena, MT 59601

Missoula

9550 Derby Drive, Missoula, MT 59808

Helena

17 Industry Loop, East Helena, MT 59635

Home
Commercial Roofing
- Versico Roofing Systems
- GAF Roofing Systems
Metal Roofs
Green Roofs
Gallery
About Us
Apply Here with BambooHR!
Contact
Employees
- Training Resources

Fall Protection Safety Test

First Name

Last Name

Email

Phone

1. Fall protection is required under OSHA construction rules as of heights of _____ feet or greater.

A. 4

B. 6

C. 7 1/2

D. 10

2. Construction workers inspecting, investigating or assessing a roof before the start of the construction or after all work has been completed are not required to have fall protection.

A. True

B. False

16. OSHA does not have a specific construction standard setting out requirements for personal fall-restraint systems.

A. True

B. False

3. Under OSHA rules, the attachment point to the wearer of a body harness in a personal fall-arrest system must be located:

A. Wherever the manufacturer has installed D-rings on the harness

B. At the waist level in front

C. At chest level in front

D. In the center of the back near shoulder level

4. Under Subpart M, warning lines must be a what height to comply with OSHA rules?

A. There is no height minimum or maximum.

B. 39 to 45 inches from the roof surface

C. 34 to 39 inches from the roof surface

D. 42 inches from the roof surface

5. What is the maximum number of workers a safety monitor is allowed to monitor under OSHA rules?

A. There is no stated maximum.

B. 8

C. 10

D. 12

6. Under OSHA rules, a leading edge and underprotected side or edge are not treated any differently for fall-protection purposes.

A. True

B. False

7. Under the OSHA steel erection standard, fall protection for workers who are not connectors or in a controlled decking zone must be provided at heights greater than _____feet.

A. 6

B. 10

C. 12

D. 15

8. Anchors used as attachment for personal fall-arrest equipment must be capable of supporting ________pounds per worker attached

A. 900

B. 1,800

C. 3,500

D. 5,000

9.Guardrails must be capable of withstanding ______ pounds of force applied within 2 inches of the top edge in any downward or outward direction at any point along the top edge.

A. 200

B. 500

C. 1,000

D. 5,000

10. When used as fall protection, nets may not be placed more than ______feet below the working level.

A. 8

B. 10

C. 13

D. 30

11. An unprotected side or edge under OSHA rules means a side or edge without a wall or guardrail system at least _____inches in height.

A. 34

B. 36

C. 39

D. 42

12.Mechanical equipment may not be used or stored in any area where a safety monitor is being used to monitor workers engaged in roofing work on low-slope roofs.

A. True

B. False

13. A safety monitor shall:

A. Be competent to recognize hazards

B. Be close enough to communicate orally with the worker

C. Not have other responsibilities that could take the monitor's attention from the monitoring function

D. All of the above

14. When mechanical equipment is being used, the warning line shall be erected no less than ______ feet from teh roof edge, which is perpendicular to the direction of mechanical equipment movement.

A. 5

B. 10

C. 6

D. 12

15. A fall-protection plan may be used in residential construction if conventional fall protection:

A. Is expensive and difficult to use

B. Is infeasible or creates a greater hazard

C. Could also be used

D. Has been rejected by a competent person

17. Snaphooks must have a minimum tensile strength of ______pounds under OSHA construction rules.

A. 220

B. 310

C. 1,000

D. 5,000

18. OSHA Defines a steep-slope roof as one with a slope greater than _______.

A. 4:12

B. 6:12

C. 8:12

D. 10:12

19. While performing roofing work on low-slope roofs 50 feet wide or less, OSHA allows a safety-monitoring system alone to be used as fall protection.

A. True

B. False

20. The rope, wire or chain making up the line in a warning-line system must have a tensile strength of _______pounds.

A. 500

B. 1,000

C. 2,000

D. 5,000

We have your submission! Thank you for taking the Fall Protection Safety Test!

Oops, there was an error sending your message.
Please try again later.

Home
Commercial Roofing
- Versico Roofing Systems
- GAF Roofing Systems
Metal Roofs
Green Roofs
Gallery
About Us
Apply Here with BambooHR!
Contact
Employees
- Training Resources

Contact Information

Phone:
406-829-9100 (Missoula)

406-443-3922 (Helena)

Email: info@summitroofing.info

Certified in GAF, Versico, Fibertite, Sarnafil, Carlisle, Genflex, and Johns Manville

Mon - Fri: 8:00 am - 5:00 pm
Sat - Sun: Closed

Visa Payment Accepted

MasterCard Payment Accepted

American Express Payment Accepted

Discover Payment Accepted

PayPal Payment Accepted

Check Payment Accepted

GAF Master Commercial Roofing Contractor

National Roofing Contractors Association

Our Location

Address:

9550 Derby Drive, Missoula, MT 59808

17 Industry Loop, East Helena, MT 59635

Serving the Whole State of Montana

Content, including images, displayed on this website is protected by copyright laws. Downloading, republication, retransmission or reproduction of content on this website is strictly prohibited. Terms of Use | Privacy Policy

Share by: